NEW !

Debut of light load braking / holding brake.
It also capable of overload protection (slip mechanism).

Small brake in clutch size
It adopts our own spring brake method, not friction brake with plate.

Quiet design (Idling)
With the internal clutch mechanism, there is no sliding noise during idle caused by friction plate.

Custom setting of 0.05 to 0.2 N ⋅ m is possible
Custom setting of brake torque (0.05 to 0.2 N ⋅ m) is possible, it corresponds to a wide range of applications.

Improvement of work efficiency by easy installation
Easy to install with screws only. It is unnecessary to adjust the gap by part disassembly at the time of installation.

Work with irregular overload
With the slipping mechanism, it can be used as a protection device for the drive unit.
Also, forcible operation at the time of power failure is realized by the same mechanism.
* The method depends on usage.

Braking, holding brake (normally used)
Position holding and overload protection device of robot arm, etc.
Maintaining the stop position of electric curtain and window blind, and forced operation at power failure